Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (MANUAL A/C-HEATER SYSTEMS (SPECIFICATIONS))TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs (N.m) | ||
|---|---|---|---|
| A/C Compressor Retaining Bolt/Nut | 18 (24) | ||
| Floor Shift Assembly Nut | 15 (20) | ||
| Generator Mounting Bolt | |||
| 2.4L 4-Cyl. | |||
| Large Bolt | 38 (52) | ||
| Small Bolt | 15 (21) | ||
| 3.0L V6 | |||
| Adjusting Bolt | 13 (18) | ||
| Pivot Bolt | 43 (58) | ||
| Instrument Panel Brace Sub-Assembly Bolt/Nut | 21 (29) | ||
| Instrument Panel Reinforcement Bolt/Nut | 21 (29) | ||
| Steering Column Assembly Bolt/Nut | 15 (20) | ||
| Steering Wheel Retaining Nut | 37 (51) | ||
| INCH Lbs. (N.m) | |||
| A/C-Heater Core Assembly Bolt/Nut | 87 (9.8) | ||
| Blower Assembly Bolt/Nut | 87 (9.8) | ||
| Condenser Retaining Bolt | 87 (9.8) | ||
| Cooler Drier-To-Modulator Cap | 109 (12.3) | ||
| Driver's Air Bag Assembly Bolt | 78 (8.8) | ||
| ECM Retaining Nut | 49 (5.5) | ||
| Expansion Valve Bolt | 48 (5.4) | ||
| Instrument Panel Junction Block Bolt/Nut | 87 (9.8) | ||
| Radiator Upper Support Bolt | 87 (9.8) | ||
| Refrigerant Line-To-Compressor Bolt | 87 (9.8) | ||
| Refrigerant Line-To-Condenser Bolt | 48 (5.4) | ||
| Refrigerant Line-To-Evaporator Bolt | 48 (5.4) | ||
| Skid Control ECU Retaining Nut | 87 (9.8) | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.