Seat Heater Control System

2004 Toyota Celica GT, StandardSECTION Seat Heater Control System
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
SEAT HEATER CONTROL SYSTEM - TROUBLESHOOTING

Symptom Suspect Area See Section
Seat heater does not operate.
  1. FRS/HTR Fuse
  2. P-IG Fuse
  3. P IG1 Relay
  4. Seat Heater Switch (Telltale Light Switch)
  5. Seat Heater
  6. Wire Harness
  1. POWER SOURCE
  2. POWER SOURCE
  3. POWER SOURCE
  4. INSPECTION
  5. INSPECTION
  6. -
Driver's seat heater does not operate.
  1. Seat Heater Switch (Telltale Light Switch)
  2. Wire Harness
  1. INSPECTION
  2. -
Passenger's seat heater does not operate.
  1. Seat Heater Switch (Telltale Light Switch)
  2. Wire Harness
  1. INSPECTION
  2. -
Seat heater temperature is too hot.
  1. Seat Heater
  1. INSPECTION
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.