Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 42 (MANUAL A/C-HEATER SYSTEMS)AIR CONDITIONING CONTROL ASSEMBLY (CENTER CLUSTER INTEGRATION)REMOVAL
2004 Toyota Celica GT, Standard
Air Conditioning Control Assembly (Center Cluster Integration): Removal
2004 Toyota Celica GT, StandardSECTION Removal
WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
Remove center cluster integration panel.
- Remove the 3 heater control knobs.
- Remove the 5 screws.
- Remove integration control panel by pulling the portions indicated by arrows in the illustration.
- Disconnect the connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.