On-Vehicle Inspection

2004 Toyota Celica GT, StandardSECTION On-Vehicle Inspection
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
  1. FUNCTION CHECKΒ 
    1. Check that the key reminder warning buzzer will sound.
      1. With the driver's door close, insert the key into the ignition switch lock cylinder, and then turn the key to the LOCK or ACC.
      2. Then, check that the buzzer will sound intermittently if the driver's door is opened.
    2. Check that the key reminder warning buzzer will stop.
      1. Check that the buzzer will stop if any of the following operations is done while the buzzer is sounding.
      2. Close the driver's door (front door courtesy lamp switch assembly is OFF).
      3. Turn the ignition switch ON.
      4. Pull out the key from the ignition switch lock cylinder.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.