Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 330 (AIR CONDITIONING SYSTEM)TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Compressor Mounting Bolt | 18 (25) |
| Discharge Line (Block Joint) | 16 (22) |
| Discharge Hose-To-Discharge Tube Nut | 16 (22) |
| Drive Belt Tension/Idle Pulley Lock Nut | 30 (41) |
| Passenger's Side Air Bag Bolt | 15 (20) |
| Suction Line (Block Joint) | 24 (33) |
| Suction Hose-To-Suction Tube Nut | 24 (32) |
| Engine Coolant Temperature Switch To Radiator | 25 (34) |
| INCH Lbs. (N.m) | |
| Clutch Pressure Plate-To-Compressor Shaft Bolt | 115 (13) |
| Drier-To-Modulator Cap | 109 (12.3) |
| Driver's Side Air Bag Bolt | 78 (8.8) |
| Expansion Valve Bolts | 30 (3.5) |
| Heater Water Pump To Engine | 48 (5.4) |
| Liquid Line (Block Joint) | 88 (10) |
| Pressure Switch | 88 (10) |
| Refrigerant Hose-To-Compressor Bolt | 88 (10) |
| Refrigerant Hose-To-Condenser Bolt | 48 (5.4) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.