Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
2004 Toyota Celica GT, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Check jam protection limit switch
. See
(11) - INSPECT JAM PROTECTION FUNCTION
.
- NG: Replace the power window motor.
- OK : Go to 2.
- Check wire harness and connector between jam protection limit switch and driver door ECU.
- NG: Repair or replace wire harness or connector.
- OK : Proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS TABLES .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.