Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 318 (TRANSMISSION CONTROL SYSTEM TRANSAXLE)COUNTER DRIVE GEARREASSEMBLY
2004 Toyota Celica GT, Standard
Counter Drive Gear: Reassembly
2004 Toyota Celica GT, StandardSECTION Reassembly
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Install ball bearing RH (MG1 side)
.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Using SST and a press, press in the ball bearing.
SST 09950-60010 (09951-00460), 09950-70010 (09951-07100).
- Install ball bearing LH (MG2 side)
.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Using SST and a press, press in the ball bearing.
SST 09950-60010 (09951-00330, 09951-00460), 09950-70010 (09951-07100).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.