Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 310 (HV BATTERY CONTROL SYSTEM - DIAGNOSTICS)
2004 Toyota Celica GT, Standard
Section 310 (HV Battery Control System - Diagnostics)
2004 Toyota Celica GT, StandardSECTION Section 310 (HV Battery Control System - Diagnostics)
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Service Precautions
- How To Proceed With Troubleshooting HV Battery Control System
- Customer Problem Analysis Check
- Pre-Check
- Diagnostic Trouble Code Chart
- Parts Location
- Terminal Of Ecu
- Circuit Inspection
- DTC P1600: Back Up Power Source Circuit Malfunction
- DTC P3001: Battery Ecu Malfunction
- DTC P3002: HV Ecu Communication Malfunction
- DTC P3005: High Voltage Fuse Snapped
- DTC P3006: Battery Soc Are Uneven
- DTC P3009: Leak Detected
- DTC P3010: Battery Total Resistance Malfunction
- DTC P3011-P3029: Battery Block # Malfunction
- DTC P3030: Battery Voltage Detective Line Snapped
- DTC P3060: Battery Temperature Sensor Circuit Malfunction
- DTC P3076: Abnormal Air Flow By Battery Cooling Fan
- DTC P3077: Battery Cooling Fan Motor Circuit Malfunction
- DTC P3115: HV Battery Current Sensor Malfunction
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.