SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 265 (DRIVER DOOR CONTROL SYSTEM - DIAGNOSTICS)CIRCUIT INSPECTIONJAM PROTECTION LIMIT SWITCH CIRCUITINSPECTION PROCEDURE
2004 Toyota Celica GT, Standard

Inspection Procedure

2004 Toyota Celica GT, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step  1 and in case of not using the TOYOTA hand-held tester, start from step  2.
  1. Check jam protection limit switch using TOYOTA hand-held tester. 

    Preparation  : connect the TOYOTA hand-held tester to the DLC 3.

    CHECK  : the jam protection limit switch using DATA LIST.

    1. OK  : Proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS TABLES .
    2. NG  , go to step  2.
  2. Check jam protection limit switch  . See step 11 of INSPECTION .
    1. NG  : Replace the power window motor.
    2. OK  , go to step  3.
  3. Check wire harness and connector between jam protection limit switch and driver door ECU. 
    1. NG  : Repair or replace wire harness or connector.
    2. OK  : Proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS TABLES .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.