Headlight And Taillight System (W/DRL)

2004 Toyota Celica GT, StandardSECTION Headlight And Taillight System (W/DRL)
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

This system uses the multiplex communication system, so check diagnosis system of the multiplex communication system before you proceed with troubleshooting.

HEADLIGHT SYSTEM (W/DRL)

Symptom/Suspect Area See
Only One Headlight Comes On
Bulb .....
Wire Harness .....
"Lo-Beam" Does Not Light (All)
Headlight Control Relay (1)
DRL Fuse (2)
Dimmer Relay (3)
Daytime Running Light No. 4 Relay (4)
Body ECU (5)
Wire Harness .....
"Lo-Beam" Does Not Light (One Side)
Bulb .....
H-LP L-LWR Fuse (2)
H-LP R-LWR Fuse (2)
Wire Harness .....
"Hi-Beam" Does Not Light (All)
Headlight Dimmer Switch (6)
DRL Fuse (2)
Dimmer Relay (3)
Daytime Running Light No. 4 Relay (4)
Body ECU (5)
Wire Harness .....
"Hi-Beam" Does Not Light (One Side)
Bulb .....
H-LP L-UPR Fuse (2)
H-LP R-UPR Fuse (2)
Wire Harness .....
"Flash" Does Not Light
Headlight Dimmer Switch (6)
Wire Harness .....
Headlight Does Not Come On
Headlight Control Relay (1)
Dimmer Relay (3)
Daytime Running Light No. 4 Relay (4)
Headlight Dimmer Switch (6)
Light Control Switch (7)
Wire Harness .....
Body ECU (5)
Bulb .....
Headlight Does Not Go Out With Light Control Switch In Off
Headlight Control Relay (1)
Dimmer Relay (3)
Wire Harness -
Headlight Flickers
Bulb .....
Body ECU (5)
Wire Harness .....
Headlight Is Dark
Bulb .....
Body ECU (5)
Wire Harness .....
Tailight Does Not Come On With Light Control Switch In Tail
Tail Fuse (2)
Taillight Control Relay (8)
Light Control Switch (7)
Wire Harness .....
Tailight Does Not Go Out With Light Control Switch In OFF
Taillight Control Relay (8)
Light Control Switch (7)
Wire Harness .....
Headlight Does Not Come ON With Engine Running And Light Control Switch In Off
ECU-B Fuse (2)
DRL Fuse (2)
Daytime Running Light No. 4 Relay (4)
Parking Brake Switch (9)
Wire Harness .....
(1) INSPECT HEADLIGHT CONTROL RELAY CONTINUITY
(2) FUSES & CIRCUIT BREAKERS
(3) INSPECT DIMMER RELAY CIRCUIT
(4) INSPECT D.R.L. RELAY CIRCUIT
(5) HOW TO PROCEED WITH TROUBLESHOOTING
(6) INSPECT HEADLIGHT DIMMER SWITCH CONTINUITY
(7) INSPECT LIGHT CONTROL SWITCH CONTINUITY
(8) INSPECT TAILLIGHT CONTROL RELAY CONTINUITY
(9) INSPECT PARKING BRAKE SWITCH
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.