Control Units

2004 Toyota Celica GT, StandardSECTION Control Units
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
CONTROL UNITS LOCATION

Component Location
Absorber Control ECU Behind left end of dash. See Figure.
A/C Control Assembly Behind center of dash. See Figure.
Adjustable Pedal ECU Behind left side of dash. See Figure.
Blower Motor Controller Behind right side of dash. See Figure.
Body ECU Attached to driver side J/B. See Figure.
Door Lock Control Receiver At right "C" pillar. See Figure.
Driver Door ECU In middle of left front door. See Figure.
Engine Control Module Behind right side of dash. See Figure.
Front Passenger Door ECU In middle of right front door. See Figure.
Headlight Beam Level Control ECU Behind lower center of dash. See Figure.
Headlight Control ECU (Left/Right) Behind respective headlight. See Figure.
Left Rear Door ECU In left rear door. See Figure.
Memory Mirror ECU Behind lower center of dash. See Figure.
Memory Seat ECU Below left front seat. See Figure.
Moon Roof Control ECU & Motor At center front of roof. See Figure.
Navigation Amplifier Behind right end of dash. See Figure.
Occupant Classification ECU Below right front seat. See Figure.
Rear Door ECU (Left) In middle of left rear door. See Figure.
Rear Door ECU (Right) In middle of right rear door. See Figure.
Right Rear Door ECU In right rear door. See Figure.
Shift Lock Control ECU Under center floor console. See Figure.
Skid Control ECU (W/Actuator) At right side of engine compartment. See Figure.
Stereo Component Amplifier (Except Mark Levinson) Behind right side of dash. See Figure.
Stereo Component Amplifier (Mark Levinson) On right side of luggage compartment. See Figure.
Theft Deterrent ECU Behind right side of dash. See Figure.
Transponder Key Amplifier On right side of steering column. See Figure.
Transponder Key Computer Behind right side of dash. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.