Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 175 (SERVICING A/T)TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Drain & Fill Plug | 15 (20) |
| Front Exhaust Pipe-To-TWC Bolt | 32 (44) |
| Front Exhaust Support Bracket Bolt | 32 (44) |
| Heated Oxygen Sensor Bolt | 32 (44) |
| INCH Lbs. (N.m) | |
| Center Floor Crossmember Brace Bolt | 124 (14) |
| Heat Insulator Bolt | 44 (5) |
| Oil Filter Bolt | 89 (10) |
| Oil Pan Bolt | 62 (7) |
| Shift Lever Nut | 124 (14) |
| Shift Rod Bolt | 124 (14) |
| PNP Switch Bolt | 124 (14) |
| PNP Switch Lock Nut | 62 (7) |
| Solenoid Valve Connector Bolt | 44 (5) |
| Solenoid Valves No. 1 & 3 | 53 (6) |
| Solenoid Valves No. 2 & 4 | 89 (10) |
| Solenoid Valve SLN | 89 (10) |
| Solenoid Valves SLT & SLU | 53 (6) |
| Solenoid Valve Wiring Clamp Bolt | 53 (6) |
| Valve Body Bolt | 89 (10) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.