Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 174 (ELECTRICAL COMPONENT LOCATOR)SWITCHES
2004 Toyota Celica GT, Standard
Section 174 (Electrical Component Locator): Switches
2004 Toyota Celica GT, StandardSECTION Switches
WARNING: This page is about a different car, the 2003 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| A/C Triple Pressure Switch | On left front of engine compartment, behind bumper fascia. See Figure. |
| Buckle Switch (Left) & Tension Reducer | Under right side of driver's seat. |
| Buckle Switch (Right) & Seat Belt Warning Occupant Detection Sensor | Under passenger's seat. |
| Engine Hood Courtesy Switch | On front of engine compartment, near hood latch. |
| Oil Pressure Switch | On left side of engine. See Figure. |
| Parking Brake Switch | At base of parking brake lever. See Figure. |
| Park/Neutral Position Switch | Behind left side of dash. See Figure. |
| Stoplight Switch | Above brake pedal, on bracket. See Figure. |
| Unlock Warning Switch & Key Interlock Solenoid | Behind left side of dash. See Figure. |
| Water Temperature Switch | On lower right front of engine compartment. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.