Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 139 (CRUISE CONTROL SYSTEMS)REMOVAL & INSTALLATIONCRUISE CONTROL SWITCHREMOVAL
2004 Toyota Celica GT, Standard
Cruise Control Switch: Removal
2004 Toyota Celica GT, StandardSECTION Removal
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure front wheels are in straight-ahead position and ignition switch is off. Disconnect and shield negative battery cable.
- Remove both screw covers. Loosen steering wheel pad Torx screws until groove along screw circumference catches on screw case. See Fig 1.
- Pull steering wheel pad away from steering wheel and disconnect air bag connector. Remove steering wheel pad assembly. Place steering wheel pad assembly on a flat surface with pad cover facing upward. If assembly is stored face down, accidental air bag deployment could propel assembly and cause serious bodily injury.
- Disconnect electrical harness connector. Remove steering wheel nut. Place match marks on steering wheel and mainshaft for installation reference. Using steering wheel puller, remove steering wheel. Remove cruise control switch screws and cruise control switch from steering wheel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.