SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 130 (BODY CONTROL SYSTEMS)SYSTEM TESTSTEST NO. 54: ALL POWER WINDOWS DO NOT OPERATE & POWER DOOR LOCKS DO NOT OPERATE
2004 Toyota Celica GT, Standard

Test No. 54: All Power Windows Do Not Operate & Power Door Locks Do Not Operate

2004 Toyota Celica GT, StandardSECTION Test No. 54: All Power Windows Do Not Operate & Power Door Locks Do Not Operate
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check all four power window fuses: FL P/W (25-amp), FR P/W (20-amp), RL P/W (20-amp) and RR P/W (20-amp) located in driver side junction block. See Figure. See POWER WINDOWS in SYSTEM WIRING DIAGRAMS article. For additional wiring for power supply circuit, see POWER DISTRIBUTION in SYSTEM WIRING DIAGRAMS article. If any fuse is defective, repair wiring for appropriate fuse and replace fuse. After repairs, perform confirmation test. See CONFIRMATION TEST .
  2. Check power main relay. See POWER MAIN RELAY  under COMPONENT TESTS. If power main relay is defective, replace power main relay. After repairs, perform confirmation test. See CONFIRMATION TEST . If power main relay is okay, check power window wiring harnesses and electrical connectors for an intermittent problem. See POWER WINDOWS in SYSTEM WIRING DIAGRAMS article. Repair wiring harness or electrical connector as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.