Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis & Repair
2004 Toyota Celica GT, StandardSECTION Diagnosis & Repair
WARNING: This page is about a different car, the 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Access ECM behind glove box. See Figure. Using DVOM, backprobe ECM harness connector and measure voltage between ground and terminal No. 1 (Black/White wire) at ECM harness connector E5. See Figure. If voltage is not 9-14 volts, go to next step. If voltage is 9-14 volts, replace ECM.
- Remove EFI fuse (20-amp) from engine compartment fuse box. Inspect EFI fuse. If EFI fuse is okay, reinstall fuse. Check wiring harness and electrical connectors between EFI fuse and ECM. See WIRING DIAGRAMS article. It may be necessary to check wiring between battery and EFI fuse. For additional wiring for EFI fuse to the battery, see POWER DISTRIBUTION article in WIRING DIAGRAMS . If EFI fuse is defective, replace fuse and check for short in wiring harness and components connected to EFI fuse. See WIRING DIAGRAMS article. Repair wiring harness or electrical connectors as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.