Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTING SYSTEM (SERVICE SPECIFICATIONS)TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Part Tightened | N.m | kgf.cm | in.lbf |
|---|---|---|---|
| Starter at Transaxle | 37 | 380 | 28 ft.lbf |
| End cover at Brush holder | 3.8 | 39 | 34 |
| Starter housing at Magnetic switch | 9.3 | 95 | 82 |
| End cover at Starter housing | 9.3 | 95 | 82 |
| Lead wire at Terminal C of starter | 5.9 | 60 | 52 |
| Terminal nut at Terminal C of starter, Terminal 30 of starter | 17 | 173 | 12 ft.lbf |
| Magnetic switch end cover at Magnetic switch | 2.5 | 26 | 23 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.