Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (SERVICE SPECIFICATIONS)TORQUE SPECIFICATIONS
2004 Toyota Celica GT, Standard
Torque Specifications
2004 Toyota Celica GT, StandardSECTION Torque Specifications
Torque Specifications
| Part tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Bearing retainer x Drive end frame | 3.0 | 31 | 27 in..lbf | |
| Rectifier end frame x Drive end frame | Nut A | 4.5 | 46 | 40 in..lbf |
| Nut B | 5.4 | 55 | 48 in..lbf | |
| Generator pulley x Rotor | 111 | 1,125 | 81 | |
| Rectifier end frame x Brush holder, Voltage regulator | 2.0 | 20 | 17 in..lbf | |
| Rectifier holder x Coil lead on rectifier end frame | 2.9 | 30 | 25 in..lbf | |
| Rear end cover x Rectifier holder | 4.4 | 45 | 39 in..lbf | |
| Plate terminal x Rectifier holder | Nut | 4.4 | 45 | 39 in..lbf |
| Bolt | 3.9 | 39 | 35 in..lbf | |
| Terminal insulator x Rectifier holder | 4.1 | 42 | 36 in..lbf | |
| Generator x RH engine mount bracket | 25 | 20 | 18 | |
| Generator x Cylinder block | 1ZZ-FE | 54 | 550 | 40 |
| 2ZZ-GE | 58 | 590 | 43 | |
| Generator x Generator bracket | 29 | 295 | 21 | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.