Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2002HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSRECALL - CHILD PROTECTION LOCK MODIFICATIONTECHNICAL INSTRUCTIONSVI. SSC COMPLETION LABEL INSTALLATION
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
VI. SSC Completion Label Installation
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION VI. SSC Completion Label Installation
1. After completing the repair and before returning the vehicle to the owner, an SSC completion label that is enclosed in the owner's notification letter must be affixed to the left front door hinge post near the check strap.
2. The label is to be filled out as follows:
^ Write in SSC40B.
^ Write in the date the repair was performed.
Write in your dealer code.
3. Additional SSC completion labels, in sheets of 50 (P/N 00410-01917), may be ordered through the non-parts system on a 1450 order form or through the TDN system.
2. The label is to be filled out as follows:
^ Write in SSC40B.
^ Write in the date the repair was performed.
Write in your dealer code.
3. Additional SSC completion labels, in sheets of 50 (P/N 00410-01917), may be ordered through the non-parts system on a 1450 order form or through the TDN system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.