Hydraulic Control Assembly - Antilock Brakes

2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Hydraulic Control Assembly - Antilock Brakes
ABS & Traction actuator (W/ VSC) bleeding Torque 8.3 Nm
Brake Actuator bracket assy installation Brake actuator w/ nuts installation Torque 19 Nm
Brake lines to master cylinder using SST Torque 15 Nm
Connect brake line to correct position of brake actuator using SST Torque 15 Nm
Installation of tube clamp to bottom side of brake actuator w/ bolt installation Torque 5.5 Nm
ABS & Traction actuator w/ bracket installation Brake actuator w/ nuts installation Torque 19 Nm
Brake lines to master cylinder using SST Torque 15 Nm
Connect brake line to correct position of brake actuator using SST Torque 15 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.