Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2002HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONAUXILIARY POWER OUTLETSERVICE AND REPAIRCENTER
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
Center
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Center
REPLACEMENT / Power Outlet Socket Assembly CTR
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
2. REMOVE POWER OUTLET SOCKET ASSEMBLY CTR
a. Disengage the meshing of the power outlet socket assembly ctr and the power outlet socket cover by rotating the cigarette lighter assembly.
b. Pull out the power outlet socket assembly ctr.
3. INSTALL POWER OUTLET SOCKET ASSEMBLY CTR
a. Aligning the socket with the cutout of the power outlet socket cover, fully push it to install.
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER
2. REMOVE POWER OUTLET SOCKET ASSEMBLY CTR
a. Disengage the meshing of the power outlet socket assembly ctr and the power outlet socket cover by rotating the cigarette lighter assembly.
b. Pull out the power outlet socket assembly ctr.
3. INSTALL POWER OUTLET SOCKET ASSEMBLY CTR
a. Aligning the socket with the cutout of the power outlet socket cover, fully push it to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.