Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2002HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINETOOLS AND EQUIPMENT
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
Engine: Tools and Equipment
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Tools and Equipment
Engine Mechanical - SST Part 1:
Engine Mechanical - SST Part 2:
Engine Mechanical - SST Part 3:
Engine Mechanical - SST Part 4:
Engine Mechanical - SST Part 5:
Engine Mechanical - SST Part 6:
Engine Mechanical - Recommended Tools Part 1:
Engine Mechanical -Recommended Tools:
Equipment
Reamer
V-block
Piston ring compressor
Piston ring expander
Valve seat cutter
Connecting rod aligner
Cylinder gauge
Micrometer
Precision straight edge
Steel square
Spring tension gauge
OBD II scan tool
CO/HC meter
Compression gauge
Radiator cap tester
Tachometer
Dial indicator with magnetic base
Toe-in gauge
Alignment tester
Tire pressure gauge
Engine Sling Device
Vernier calipers
Spark Plug Gap Gauge
Belt tension gauge
Chain Block
Universal engine lifter
Torque wrench
Plastic Hammer
Chisel
Plastic Gauge
Heater
12 mm Socket Wrench for 12 Pointed Head
Deep Socket Wrench 24 mm
Spark plug cleaner
Spring tester
Angle gauge
Engine Mechanical - SSM:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.