Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2002HIGHLANDER 4WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSPOWER AND GROUND DISTRIBUTIONSYSTEM DIAGRAMSERVICE HINTS
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)
Service Hints
2002 Toyota Highlander 4WD L4-2.4L (2AZ-FE)SECTION Service Hints
I15 Ignition SW
2 - 3 : Closed with the ignition SW at ACC or ON position
2 - 4 : Closed with the ignition SW at ON or ST position
2 - 1 : Closed with the ignition SW at ST position
7 - 6 : Closed with the ignition SW at ON or ST position
7 - 8 : Closed with the ignition SW at ST position
TAIL Relay
5 - 3 : Closed with the light control SW at HEAD or TAIL position
HEAD Relay
5 - 3 : Closed with the light control SW at HEAD position or dimmer SW at FLASH position Closed with the engine running and parking brake released (Parking brake SW off)
2 - 3 : Closed with the ignition SW at ACC or ON position
2 - 4 : Closed with the ignition SW at ON or ST position
2 - 1 : Closed with the ignition SW at ST position
7 - 6 : Closed with the ignition SW at ON or ST position
7 - 8 : Closed with the ignition SW at ST position
TAIL Relay
5 - 3 : Closed with the light control SW at HEAD or TAIL position
HEAD Relay
5 - 3 : Closed with the light control SW at HEAD position or dimmer SW at FLASH position Closed with the engine running and parking brake released (Parking brake SW off)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.