Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001LANDCRUISER V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLEFLUID PUMP, A/TSERVICE SPECIFICATIONS
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)
Service Specifications
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)SECTION Service Specifications
OIL PUMP
Body Clearance
Standard 0.07 - 0.15 mm (0.0028 - 0.0059 inch)
Maximum 0.3 mm (0.012 inch)
Tip Clearance
Standard 0.11 - 0.14 mm (0.0043 - 0.0055 inch)
Maximum 0.3 mm (0.012 inch)
Side Clearance
Standard 0.02 - 0.05 mm (0.0008 - 0.0020 inch)
Maximum 0.1 mm (0.004 inch)
Pump Body Bushing Inside Diameter
Maximum 38.19 mm (1.5035 inch)
Stator Shaft Bushing Inside Diameter
Front Side, Maximum 21.58 mm (0.8496 inch)
Rear Side, Maximum 27.08 mm (1.0661 inch)
Body Clearance
Standard 0.07 - 0.15 mm (0.0028 - 0.0059 inch)
Maximum 0.3 mm (0.012 inch)
Tip Clearance
Standard 0.11 - 0.14 mm (0.0043 - 0.0055 inch)
Maximum 0.3 mm (0.012 inch)
Side Clearance
Standard 0.02 - 0.05 mm (0.0008 - 0.0020 inch)
Maximum 0.1 mm (0.004 inch)
Pump Body Bushing Inside Diameter
Maximum 38.19 mm (1.5035 inch)
Stator Shaft Bushing Inside Diameter
Front Side, Maximum 21.58 mm (0.8496 inch)
Rear Side, Maximum 27.08 mm (1.0661 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.