Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001LANDCRUISER V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)
Connecting Rod Bearing
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)SECTION Connecting Rod Bearing
Connecting Rod Bearing
Standard oil clearance: 0.027 - 0.053 mm (0.0011 - 0.0021 inch)
Maximum oil clearance: 0.065 mm (0.0026 inch)
If the oil clearance is greater than maximum, replace the bearings. If necessary, replace the crankshaft.
HINT: If using a standard bearing, replace it with one having the same number. If the number of the bearing cannot be determined, select the correct bearing by adding together the numbers imprinted on the connecting rod cap and crankshaft, then selecting the bearing with the same number as the total. There are 6 sizes of standard bearings, marked "2", "3", "4", "5", "6" and "7".
EXAMPLE:
Connecting rod cap "3" + Crankshaft.
= Total number 4 (Use bearing "4")
Reference
Connecting Rod Big End Inside Diameter
Crankshaft Crank Pin Diameter
Standard Sized Bearing Center Wall Thickness
Standard oil clearance: 0.027 - 0.053 mm (0.0011 - 0.0021 inch)
Maximum oil clearance: 0.065 mm (0.0026 inch)
If the oil clearance is greater than maximum, replace the bearings. If necessary, replace the crankshaft.
HINT: If using a standard bearing, replace it with one having the same number. If the number of the bearing cannot be determined, select the correct bearing by adding together the numbers imprinted on the connecting rod cap and crankshaft, then selecting the bearing with the same number as the total. There are 6 sizes of standard bearings, marked "2", "3", "4", "5", "6" and "7".
EXAMPLE:
Connecting rod cap "3" + Crankshaft.
= Total number 4 (Use bearing "4")
Reference
Connecting Rod Big End Inside Diameter
Crankshaft Crank Pin Diameter
Standard Sized Bearing Center Wall Thickness
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.