Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001LANDCRUISER V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRREAR CONTROL ASSEMBLY
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)
Rear Control Assembly
2001 Toyota Landcruiser V8-4.7L (2UZ-FE)SECTION Rear Control Assembly
Rear Heater Control Assembly:
REMOVAL
1. REMOVE REAR CONSOLE END PANEL
2. REMOVE HEATER CONTROL ASSEMBLY
a. Turn the heater control dial to "MAX. WARM" position.
b. Remove the 3 screws and heater control assembly then disconnect the connector and control cable.
INSTALLATION
1. INSTALL HEATER CONTROL ASSEMBLY
a. Connect the heater control cable.
1. Set the heater control dial to "MAX. WARM" position.
2. Connect the heater control cable to the heater control assembly.
HINT: Lock the clamp during lightly pulling the outer cable in the direction, as shown in the illustration by an arrow.
b. Connect the connector to heater control assembly.
c. Install the heater control assembly to rear console box with the 3 screws.
2. INSTALL REAR CONSOLE END PANEL
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.