Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001HIGHLANDER 2WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSCRANKSHAFT MAIN BEARING TORQUE AND SEQUENCE
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)
Crankshaft Main Bearing Torque and Sequence
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)SECTION Crankshaft Main Bearing Torque and Sequence
Main Bearing Oil Clearance
Standard 0.017-0.040 mm
Maximum 0.07 mm
Diameters:
Diameters
Use:
Use
Main Bearing Cap Torque
First Pass 20 Nm
Second Pass 40 Nm
Third Pass 90 Degrees
Sequence
Removal:
Removal
Installation:
Installation
Bearing Cap Bolt
Standard Diameter 7.3 - 7.5 mm
Minimum Diameter 7.2 mm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.