Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001HIGHLANDER 2WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORTESTING AND INSPECTION
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)
Camshaft Position Sensor: Testing and Inspection
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)SECTION Testing and Inspection
CAMSHAFT POSITION SENSOR [11102A / 98-5]
Using an ohmmeter, measure the resistance between terminals.
RESISTANCE:
cold.....................835 - 1400 ohm
hot....................1060 - 1645 ohm
NOTE: "Cold" and "Hot" on the table express the temperature of the coils themselves."Cold" is from -10 °C (14 °F) to 50 °C (122 °F) and "Hot" is from 50 °C (122 °F) to 100 °C (212 °F).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.