Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001HIGHLANDER 2WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONAUXILIARY POWER OUTLETSERVICE AND REPAIRREAR
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)
Rear
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)SECTION Rear
REPLACEMENT / Power Point Socket Assembly RR
1. REMOVE POWER POINT SOCKET ASSEMBLY RR
a. Using a screwdriver, disengage the claw on the power point socket cover from the hole in the power point socket, then pull out the power point socket approx. 10 mm (0.39 in.).
HINT: Tape the screwdriver tip before use.
b. Using a screwdriver, disengage the claw on the power point socket cover from the body and remove the power point socket and cover as a unit.
HINT: Tape the screwdriver tip before use.
c. Disconnect the connector.
d. Disassemble the power point socket from the socket cover.
2. INSTALL POWER POINT SOCKET ASSEMBLY RR
a. Assemble the power point socket to the power point socket cover at the position 10 mm (0.39 in.) away from full lock position and ensure that they are temporarily locked.
b. Align the cut-out on the body with the claw on the power point socket cover and install the power point socket and cover to the body.
c. After installing them, push in the power point socket approx. 10 mm (0.39 in.) to lock it.
1. REMOVE POWER POINT SOCKET ASSEMBLY RR
a. Using a screwdriver, disengage the claw on the power point socket cover from the hole in the power point socket, then pull out the power point socket approx. 10 mm (0.39 in.).
HINT: Tape the screwdriver tip before use.
b. Using a screwdriver, disengage the claw on the power point socket cover from the body and remove the power point socket and cover as a unit.
HINT: Tape the screwdriver tip before use.
c. Disconnect the connector.
d. Disassemble the power point socket from the socket cover.
2. INSTALL POWER POINT SOCKET ASSEMBLY RR
a. Assemble the power point socket to the power point socket cover at the position 10 mm (0.39 in.) away from full lock position and ensure that they are temporarily locked.
b. Align the cut-out on the body with the claw on the power point socket cover and install the power point socket and cover to the body.
c. After installing them, push in the power point socket approx. 10 mm (0.39 in.) to lock it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.