Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2001HIGHLANDER 2WD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE ROTOR/DISCSPECIFICATIONS
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)
Brake Rotor/Disc: Specifications
2001 Toyota Highlander 2WD L4-2.4L (2AZ-FE)SECTION Specifications
FRONT BRAKE
Standard thickness 28.0 mm (1.102 in.)
Minimum thickness 26.0 mm (1.024 in.)
Maximum disc runout 0.05 mm (0.0020 in.)
REAR BRAKE
Standard thickness 10.0 mm (0.394 in.)
Minimum thickness 8.5 mm (0.335 in.)
Maximum thickness 0.15 mm (0.0059 in.)
NOTE: Measure the disc runout 10 mm away from the outer edge of the disc.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.