Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000TACOMA REGULAR CAB 2WD L4-2.4L (2RZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIR
2000 Toyota Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE)
Vehicle Speed Sensor: Service and Repair
2000 Toyota Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE)SECTION Service and Repair
ON-VEHICLE REPAIR
1. DISCONNECT VEHICLE SPEED SENSOR CONNECTOR
2. REMOVE VEHICLE SPEED SENSOR ASSEMBLY
a. Remove the bolt and the vehicle speed sensor assembly.
b. Remove the clip and the driven gear from the vehicle speed sensor.
c. Remove the O-ring from the vehicle speed sensor.
3. INSTALL VEHICLE SPEED SENSOR ASSEMBLY
a. Coat a new O-ring with ATF and install it to the vehicle speed sensor.
b. Install the driven gear and the clip to the vehicle speed sensor.
c. Install the vehicle speed sensor assembly with the bolt.
Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)
4. CONNECT VEHICLE SPEED SENSOR CONNECTOR
1. DISCONNECT VEHICLE SPEED SENSOR CONNECTOR
Vehicle Speed Sensor NO.1 (A43D):
2. REMOVE VEHICLE SPEED SENSOR ASSEMBLY
a. Remove the bolt and the vehicle speed sensor assembly.
b. Remove the clip and the driven gear from the vehicle speed sensor.
c. Remove the O-ring from the vehicle speed sensor.
3. INSTALL VEHICLE SPEED SENSOR ASSEMBLY
a. Coat a new O-ring with ATF and install it to the vehicle speed sensor.
b. Install the driven gear and the clip to the vehicle speed sensor.
c. Install the vehicle speed sensor assembly with the bolt.
Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)
4. CONNECT VEHICLE SPEED SENSOR CONNECTOR
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.