Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000TACOMA BASE, 2D PICKUP, 2.4 L, STANDARDREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURESWHEEL ALIGNMENT SPECIFICATIONSAVALON
2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, Standard
Wheel Alignment Specifications: AVALON
2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, StandardSECTION AVALON
WHEEL ALIGNMENT SPECIFICATIONS (AVALON)
| Application | Preferred | Range | ||||||
|---|---|---|---|---|---|---|---|---|
| Camber (1) | ||||||||
| Front | -0.62 | -1.37 To 0.13 | ||||||
| Rear | ||||||||
| 1999 | -0.77 | -1.52 To -0.02 | ||||||
| 2000 | -0.72 | -1.47 To 0.03 | ||||||
| Caster (1) | ||||||||
| Front | ||||||||
| 1999 | 2.18 | 1.43 To 2.93 | ||||||
| 2000 | 2.17 | 1.42 To 2.92 | ||||||
| Steering Axis Inclination (1) | 13.07 | ...... | ||||||
| Toe-In (2) | ||||||||
| Front | 0 (0) | -0.08 To 0.08 (-2 To 2) | ||||||
| Rear | 0.16 (4) | 0.08 To 0.24 (2 To 6) | ||||||
| Toe-In (1) | ||||||||
| Front | 0 | -0.2 To 0.2 | ||||||
| Rear | 0.4 | 0.2 To 0.6 | ||||||
| Toe-Out On Turns (1) | ||||||||
| 1999 | ||||||||
| Inner | 35.78 | ..... | ||||||
| Outer | 31.42 | ..... | ||||||
| 2000 | ||||||||
| Inner | 35.75 | ..... | ||||||
| Outer | 31.38 | ..... | ||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.