Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000TACOMA BASE, 2D PICKUP, 2.4 L, STANDARDREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURESRIDING HEIGHT ADJUSTMENTRIDING HEIGHT MEASUREMENT POINTSRAV4
2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, Standard
Riding Height Measurement Points: RAV4
2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, StandardSECTION RAV4
Measure front riding height from ground to center of lower arm mounting bolt. Measure rear riding height from ground to center of body side No. 1 suspension arm mounting bolt.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.