SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000TACOMA BASE, 2D PICKUP, 2.4 L, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTPOWER MIRRORSCOMPONENT TESTSPOWER MIRROR MOTOR
2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, Standard

Power Mirror Motor

2000 Toyota Tacoma Base, 2D Pickup, 2.4 L, StandardSECTION Power Mirror Motor
NOTE: Mirror motor harness connectors may vary in configuration from vehicle to vehicle of the same model.

Disconnect power mirror motor harness connector. Using a 12-volt power source, connect positive and negative leads to specified pins or terminals. See appropriate POWER MIRROR MOTOR TEST table. See Figure-Figure . If power mirror motor fails any test, replace power mirror assembly.

POWER MIRROR MOTOR TEST (AVALON - WITHOUT MIRROR HEATER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
3 1 Up
1 3 Down
1 2 Left
2 1 Right
(1) See Figure-Figure .
POWER MIRROR MOTOR TEST (AVALON - WITH MIRROR HEATER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
4 2 Up
2 4 Down
1 2 Left
2 1 Right
(1) See Figure-Figure .
POWER MIRROR MOTOR TEST (CAMRY - JAPAN BUILT - WITH MIRROR HEATER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
1 2 Up
2 1 Down
3 2 Left
2 3 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (CAMRY - USA BUILT - WITHOUT MIRROR HEATER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
3 2 Up
2 3 Down
1 2 Left
2 1 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (CAMRY - USA BUILT - WITH MIRROR HEATER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
1 2 Up
2 1 Down
3 2 Left
2 3 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (CAMRY SOLARA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
3 4 Up
4 3 Down
3 4 Left
4 2 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (CELICA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
5 3 Up
3 5 Down
1 3 Left
3 1 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (COROLLA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
3 2 Up
2 3 Down
1 2 Left
2 1 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (LAND CRUISER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
8 7 Left
7 8 Right
6 7 Up
7 6 Down
(1) See Figure.
POWER MIRROR MOTOR TEST (MR2)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
2 1 Right
1 2 Left
2 3 Down
3 2 Up
(1) See Figure.
POWER MIRROR MOTOR TEST (SIENNA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
2 3 Left
3 2 Right
2 1 Up
1 2 Down
(1) See Figure or Figure .
POWER MIRROR MOTOR TEST (TACOMA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
2 1 Up
1 2 Down
3 1 Left
1 3 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (TUNDRA)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
2 1 Up
1 2 Down
3 1 Left
1 3 Right
(1) See Figure.
POWER MIRROR MOTOR TEST (4RUNNER)

Apply 12 Volts To Pin No. (1) Ground Pin No. Mirror Operation
5 4 Up
4 5 Down
1 4 Left
4 1 Right
(1) See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.