Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000SIENNA LE V6-3.0L (1MZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
2000 Toyota Sienna LE V6-3.0L (1MZ-FE)
Connecting Rod Bearing
2000 Toyota Sienna LE V6-3.0L (1MZ-FE)SECTION Connecting Rod Bearing
Connecting Rod Bearing Oil Clearance
Standard 0.038-0.064 mm
Maximum 0.08 mm
Standard Bearing Center Wall Thickness
Mark 1 1.484-1.487 mm
Mark 2 1.487-1.490 mm
Mark 3 1.490-1.493 mm
Mark 4 1.493-1.496 mm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.