Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Actuator Bracket Mounting Bolts | 14 (19) |
| Brakeline Fittings | 11 (15) |
| Hub Nut | 83 (110) |
| Push Rod Lock Nut | 18 (25) |
| Speed Sensor Harness-To-Rear Suspension Arm Bolts | 9 (13) |
| INCH Lbs. (N.m) | |
| Actuator-To-Bracket Mounting Nuts | 48 (5.4) |
| Speed Sensor Harness-To-Body Bolts | 48 (5.4) |
| Wheel Speed Sensor Mounting Bolt | 71 (8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.