Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
2-Door Models
- Connect 3 "D" cell batteries in series, creating 4.5 volts. Connect VGS terminal of deceleration sensor to positive (+) side of batteries. See Fig 1. Connect GGND terminal to negative (-) side of batteries.
- Measure voltage between terminal GL1 and ground, and between terminal GL2 and ground at deceleration sensor. Ensure sensor is within specifications. See DECELERATION SENSOR SPECIFICATIONSΒ . If sensor is not within specification, replace sensor.
DECELERATION SENSOR SPECIFICATIONS
| Terminal | Position | (1)Voltage | ||
|---|---|---|---|---|
| GL1 | Horizontal | 2.3 | ||
| GL1 | Leaning Forward | 0-2.3 | ||
| GL1 | Leaning Rearward | 2.3-4.5 | ||
| GL2 | Horizontal | 2.3 | ||
| GL2 | Leaning Forward | 2.3-4.5 | ||
| GL2 | Leaning Rearward | 0-2.3 | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
