Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Toyota RAV4 2-Door 2WD L4-2.0L (3S-FE)FACTORY OEM SERVICE PROCEDURE
Manual Shifting Test
MANUAL SHIFTING TEST
HINT: By this test, it can be determined whether the trouble is in the electrical circuit or is a mechanical problem in the transaxle.
a. Disconnect the solenoid wire.
b. Inspect the manual driving operation.
Check that the shift and gear positions correspond to the table.
HINT:
- If the L, 2 and D position gear positions are difficult to distinguish, do the above road test.
- While driving, shift through the L, 2 and D positions. Check that the gear change corresponds to the shift position.
If any abnormality is found in the above test, the problem is in the transaxle itself.
c. Connect solenoid wire.
d. Clear the DTC.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.