PRECAUTION

1. BEFORE WORKING ON THE FUEL SYSTEM, DISCONNECT THE NEGATIVE (-) TERMINAL CABLE FROM THE BATTERY

HINT: Any diagnostic trouble code retained by the computer will be erased when the negative (-) terminal cable is removed from the battery. Therefore, if necessary, read the diagnosis before removing the negative (-) terminal cable from the battery.

2. DO NOT SMOKE OR WORK NEAR AN OPEN FLAME WHEN WORKING ON THE FUEL SYSTEM
3. KEEP GASOLINE AWAY FROM RUBBER OR LEATHER PARTS

4. MAINTENANCE PRECAUTIONS
a. In event of engine misfire, these precautions should be taken.
1. Check proper connection to battery terminals, etc.
2. After repair work, check that the ignition coil terminals and all other ignition system lines are reconnected securely.
3. When cleaning the engine compartment, be especially careful to protect the electrical system from water.

b. Precautions when handling oxygen sensor.
1. Do not allow oxygen sensor to drop or hit against an object.
2. Do not allow the sensor to come into contact with water.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Maintenance Precaution

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?