Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2000CAMRY LE, 3.0 F, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESPECIFICATIONSENGINE CONTROLS - SERVICE & ADJUSTMENT SPECIFICATIONSCAPACITIESLAND CRUISER FLUID CAPACITIES
2000 Toyota Camry LE, 3.0 F, Standard
Land Cruiser Fluid Capacities
2000 Toyota Camry LE, 3.0 F, StandardSECTION Land Cruiser Fluid Capacities
LAND CRUISER FLUID CAPACITIES
| Application | (1) Quantity | ||||||
|---|---|---|---|---|---|---|---|
| Crankcase (Includes Filter) (2) | 7.2 Qts. (6.8L) | ||||||
| Cooling System (Includes Heater) | |||||||
| With Front Heater Only | 15.6 Qts. (14.8L) | ||||||
| With Front & Rear Heater | 16.2 Qts. (15.3L) | ||||||
| Automatic Transmission (Dexron-III) | |||||||
| Drain & Refill | 3.7 Qts. (3.5L) | ||||||
| Dry Refill | 12.4 Qts. (11.7L) | ||||||
| Differential | |||||||
| Front Axle (SAE 80W-90/API GL-5) | 1.8 Qts. (1.7L) | ||||||
| Rear Axle | |||||||
| With Limited Slip Differential (LSD) (Hypoid Gear Oil LSD SAE 80W-90/API GL-5) | 3.5 Qts. (3.3L) | ||||||
| With Rear Differential Lock (SAE 80W-90/API GL-5) | 3.4 Qts. (3.2L) | ||||||
| Without Rear Differential Lock (SAE 80W-90/API GL-5) | 3.5 Qts. (3.3L) | ||||||
| Power Steering Fluid (Dexron-III) | .85 Qt. (.80L) | ||||||
| Transfer Case (SAE 75W-90/API GL-5) | 1.4 Qts. (1.3L) | ||||||
|
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.