Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1999CELICA 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICS - INTRODUCTIONSELF-DIAGNOSTIC SYSTEMDATA LINK CONNECTOR
1999 Toyota Celica 2D Convertible, Standard
Data Link Connector
1999 Toyota Celica 2D Convertible, StandardSECTION Data Link Connector
OBD-II regulations (SAE J-1850) standardizes Data Link Connector (DLC) configurations. See DATA LINK CONNECTOR (DLC) NO. 3 LOCATION table. See appropriate figure in appropriate SELF-DIAGNOSTICS article.
DATA LINK CONNECTOR (DLC) NO. 3 LOCATION
| Model | Location |
|---|---|
| Avalon, Camry, Camry Solara & Corolla | Left Side Of Instrument Panel, Left Of Steering Column |
| Celica, Land Cruiser, RAV4, Sienna, Tacoma & 4Runner | Left Side Of Instrument Panel, Right Of Steering Column |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.