Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Camry
With ignition switch in OFF position, remove 25-pin harness connector from integration relay. See Figure. Measure voltage between ground and terminal No. 18 (Blue/White wire) at integration relay 25-pin harness connector. See Figure. Battery voltage should exist. If battery voltage does not exist, repair Blue/White wire. If battery voltage exists, proceed to next test given under ALL FUNCTIONS OF KEYLESS ENTRY DO NOT WORK .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.