Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1999CAMRY XLE, 2.2 GREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSA/C-HEATER SYSTEM - MANUAL
1999 Toyota Camry XLE, 2.2 G
A/C-Heater System - Manual
1999 Toyota Camry XLE, 2.2 GSECTION A/C-Heater System - Manual
- Specifications
- Description
- Operation
- Adjustments
- Trouble Shooting
- Notes
- No Blower Operation
- No Air Temperature Control
- No Air Inlet Control
- No Air Outlet Control
- No Compressor Operation
- Compressor Operates Intermittently
- No Cool Air Comes Out
- Cool Air Comes Out Only At High Engine Rpm
- No Engine Idle-Up When A/C Switch Is On
- Blinking A/C Indicator
- A/C Indicator Does Not Light When Switch Is In Defrost Position
- No Condenser Fan Operation
- Testing
- Notes
- A/C System Performance
- A/C Amplifier
- A/C Switch
- Air Outlet Servomotor
- Blower Motor
- Blower Resistor
- Compressor Clutch
- Compressor Clutch Relay
- Condenser Fan Relays
- Condenser Fan Motor
- Coolant Temperature Switch (Sensor)
- Expansion Valve
- Heater Main Relay
- Idle Air Control (IAC) Valve
- Dual-Pressure Switch
- Thermistor
- Removal & Installation
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.