Symptom Diagnosis

1999 Toyota Camry XLE, 2.2 GSECTION Symptom Diagnosis

If a normal DTC is displayed during DTC check but problem still occurs, check circuits for each problem symptom in order given in SYMPTOM DIAGNOSIS , then see specified procedure or appropriate test under DIAGNOSIS & TESTING , DIAGNOSTIC TESTS , SYMPTOM TESTS  or COMPONENT TESTS  .

SYMPTOM DIAGNOSIS

Symptom Circuit Circuit, DTC Or Procedure
ABS Inoperative (1) Check DTC, Confirm Normal Code Is Output RETRIEVING DIAGNOSTIC TROUBLE CODES 
Power Source Circuit DTC 41 
Speed Sensor Circuit DTC 31-34 
Check ABS/TRAC Actuator ACTUATOR CHECK 
Check For Hydraulic Leakage Visual Inspection
ABS Inoperative Intermittently (1) Check DTC, Confirm Normal Code Is Output RETRIEVING DIAGNOSTIC TROUBLE CODES 
Speed Sensor Circuit DTC 31-34 
Stoplight Switch Circuit DTC 49 
Check ABS/TRAC Actuator ACTUATOR CHECK 
Check For Hydraulic Leakage Visual Inspection
ABS Warning Light Abnormal ABS Warning Light Circuit ABS WARNING LIGHT 
ABS/TRAC ECU ABS & TRAC OFF LIGHTS ON: ABS/TRAC ECU MALFUNCTION 
Unable To Perform DTC Check (1) ABS Warning Light Circuit ABS WARNING LIGHT 
Tc Terminal Circuit Tc TERMINAL 
Unable To Perform Speed Sensor Diagnostics Ts Terminal Circuit Ts TERMINAL 
ABS/TRAC ECU ABS & TRAC OFF LIGHTS ON: ABS/TRAC ECU MALFUNCTION 
TRAC Inoperative (1) Check DTC, Confirm Normal Code Is Output RETRIEVING DIAGNOSTIC TROUBLE CODES 
Power Source Circuit DTC 41 
Speed Sensor Circuit DTC 31-34 
Check For Hydraulic Leakage Visual Inspection
SLIP Indicator Light Abnormal SLIP Indicator Light SLIP INDICATOR LIGHT 
TRAC OFF Indicator Light Abnormal (1) TRAC OFF Indicator Light Circuit TRAC OFF INDICATOR, TRAC CUT SWITCH 
TRAC Cut Switch Circuit TRAC OFF INDICATOR, TRAC CUT SWITCH 
DTC Check Cannot Be Done (1) TRAC OFF Indicator Light Circuit TRAC OFF INDICATOR, TRAC CUT SWITCH 
Tc Terminal Circuit Tc TERMINAL 
(1) If all circuits check okay and problem is still occurring, replace ABS/TRAC ECU.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.