Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1999CAMRY XLE, 2.2 GREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEMSPROGRAMMINGVEHICLE ACCESS CODE PROGRAMMING1999 CAMRY
1999 Toyota Camry XLE, 2.2 G
1999 Camry
1999 Toyota Camry XLE, 2.2 GSECTION 1999 Camry
- Locate wireless door lock ECU below radio. See Figure. Remove remote control mirror switch connector (attached to bottom of wireless door lock ECU). Using a jumper wire, connect remote control mirror switch PRG and GND terminals. See Figure. All doors should lock and unlock. Depress any single button on No. 1 transmitter and all doors should lock and unlock.
- Program No. 2 transmitter by repeating step 1. When programming is complete, remove jumper wire from remote control mirror switch PRG and GND terminals. Operate transmitters to ensure proper programming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.