Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1997TERCEL 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVE/INSTALL/OVERHAULTORQUE SPECIFICATIONS
1997 Toyota Tercel 4D Sedan, Automatic
Torque Specifications
1997 Toyota Tercel 4D Sedan, AutomaticSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Accessory Drive Pulley-To-Crankshaft Pulley Bolt | 14 (19) | |||
| Crankshaft Pulley Bolt | 114 (155) | |||
| ECT Sensor | (1) | |||
| Front (Timing Belt End) Engine Mount Through-Bolt | 54 (73) | |||
| Front (Timing Belt End) Engine Mount-To-Mounting Bracket Bolt | 47 (64) | |||
| Fuel Inlet Hose-To-Fuel Rail Union Bolt | 22 (30) | |||
| Fuel Outlet Line-To-Fuel Pump Mounting Bracket Union Bolt | 22 (30) | |||
| Fuel Rail-To-Cylinder Head Bolt | 14 (19) | |||
| Knock Sensor | 33 (45) | |||
| Oxygen Sensor-To-Exhaust Manifold | 32 (43) | |||
| Oxygen Sensor-To-Exhaust Pipe | 32 (43) | |||
| Throttle Body Bolt/Nut | 15 (20) | |||
| Wheel Lug Nut | 76 (103) | |||
| INCH Lbs. (N.m) | ||||
| Camshaft Position Sensor Bolt | 71 (8.0) | |||
| Crankshaft Position Sensor Bolt | 71 (8.0) | |||
| Fuel Pressure Regulator Retaining Screw | 18 (2.0) | |||
| Fuel Pump Mounting Bracket-To-Fuel Tank Bolt | 31 (3.5) | |||
| Ignition Coil Bolt | 75 (8.5) | |||
| PNP Switch Retaining Bolt | 48 (5.4) | |||
| PNP Switch Retaining Nut | 61 (6.9) | |||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.