Distributor Sensors

1997 Toyota Tercel 4D Sedan, AutomaticSECTION Distributor Sensors
DISTRIBUTOR PICK-UP COIL AIR GAP

Application In. (mm)
Tercel (1)
(1) Distributorless Ignition System (DIS) is used.
DISTRIBUTOR PICK-UP COIL RESISTANCE

Application (1) Pick-Up Coil Terminals Ohms
Tercel (2) (2)
(1) For proper testing and terminal identification, see BASIC TESTING article.
(2) Distributorless Ignition System (DIS) is used.
CAMSHAFT POSITION SENSOR RESISTANCE

Application Ohms
Cold (1) 985-1600
Hot (2) 1265-1890
(1) Cold is with temperature of 14-122°F (-10-50°C).
(2) Hot is with temperature of 122-212°F (50-100°C).
CRANKSHAFT POSITION SENSOR RESISTANCE

Application Ohms
Cold (1) 985-1600
Hot (2) 1265-1890
(1) Cold is with temperature of 14-122°F (-10-50°C).
(2) Hot is with temperature of 122-212°F (50-100°C).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.