Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Turn Signal Flasher
Remove turn signal flasher. See TURN SIGNAL FLASHER LOCATION table. At turn signal flasher terminals, connect battery positive lead to terminal No. 2. See Fig 1. Connect battery negative lead to terminal No. 3. Connect 2 turn signal bulbs in parallel between terminal No. 1 and battery negative terminal. Replace turn signal flasher if bulbs do not flash 60-120 times per minute.
| Application | Location |
|---|---|
| Tercel | Behind Instrument Cluster |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.