Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1997PREVIA DX, RWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMADJUSTMENTSSTOPLIGHT SWITCH
1997 Toyota Previa DX, RWD
Stoplight Switch
1997 Toyota Previa DX, RWDSECTION Stoplight Switch
- Stoplight switch is located above brake pedal. See Figure. To adjust stoplight switch, loosen stoplight switch lock nuts, and rotate stoplight switch until it touches brake pedal stop.
- Rotate stoplight switch counterclockwise until clearance between threaded end of stoplight switch and brake pedal is .02-.09" (0.5-2.3 mm). Tighten stoplight switch lock nut. Check stoplight operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.