Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1997PREVIA DX, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION SHIFT INTERLOCK SYSTEMSADJUSTMENTSSHIFT LOCK PINPREVIA
1997 Toyota Previa DX, RWD
Shift Lock Pin: Previa
1997 Toyota Previa DX, RWDSECTION Previa
Adjust pin length by loosening and tightening nut. Pin length should be .012" (.3 mm) above or .028" (.7 mm) below shift lever assembly surface. With pin within length specifications, tighten nut to 18 ft. lbs. (25 N.m). See Figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.